Trusted ac repair for Glens Falls properties. Same-day service available, transparent pricing, and a workmanship guarantee.
When your air conditioner in Glens Falls, New York blows warm air, short cycles, or fails to start, KIC Refrigeration technicians identify the exact cause through systematic testing of the refrigerant circuit, compressor windings, capacitors, and control board. We restore reliable cooling performance with precision repairs that address the root problem, not just the symptoms.
Properties throughout Glens Falls (pop. 14,290) face unique demands when it comes to ac repair. New York heating loads, cooling calculations, and the insulation levels and duct configurations found in Glens Falls homes all influence the approach we take. KIC Refrigeration tailors every ac repair project to the conditions your property actually faces — no generic solutions.
Choosing the right contractor for ac repair in Glens Falls, NY makes all the difference between efficient comfort and a system that short-cycles. KIC Refrigeration uses Manual J load calculations, installs to manufacturer specifications, and backs every project with a warranty. Call (866) 858-2961 to schedule your free assessment.
How our NATE-certified technicians deliver quality ac repair results from start to finish.
We assess your air conditioning problem — no cooling, weak airflow, strange noises, ice buildup, or short cycling — and perform a safety check on electrical connections, circuit breaker, disconnect, and thermostat wiring before beginning hands-on diagnostics.
KIC Refrigeration diagnoses AC failures in Glens Falls, NY with precision electrical and refrigerant testing. We check capacitors within 6 percent of rated microfarads, measure contactor coil resistance, verify compressor winding resistance for shorts and opens, and test the refrigerant circuit — comparing suction pressure, discharge pressure, subcooling, and superheat to the manufacturer target values for the current outdoor ambient temperature.
Our Glens Falls technician replaces the failed part with the correct replacement for your unit make, model, and tonnage. If the failure involves the sealed refrigerant system, we recover the charge, make the repair, pressure test with nitrogen, evacuate to below 500 microns, and weigh in the correct charge of R-410A or the specified refrigerant.
We run the system for a minimum of 15 minutes, measure the temperature split across the evaporator coil (target: 16 to 22 degrees), verify suction and discharge pressures, check condenser fan and blower motor amperage, and confirm the thermostat cycles the system off at setpoint.
Get answers to the ac repair questions our customers ask most often.
AC repair in Glens Falls typically costs $150 to $500 for common component failures including run capacitors ($150 to $250), contactors ($150 to $350), condenser fan motors ($250 to $500), and blower motors ($300 to $600). Compressor replacement is the most expensive repair at $1,500 to $3,500 depending on unit tonnage and whether the system uses R-410A or older R-22 refrigerant. Evaporator coil replacement runs $800 to $2,500 including the refrigerant recovery and recharge. KIC Refrigeration provides a detailed written estimate with itemized parts and labor costs before beginning any AC repair at your Glens Falls property so there are no surprises on the invoice.
The industry guideline is to repair if the unit is under 10 years old and the repair costs less than 50 percent of a new system. AC units over 15 years old — especially those running R-22 refrigerant — are almost always better replaced. R-22 has been phased out of production and the remaining supply costs $80 to $150 per pound, making even minor refrigerant leaks prohibitively expensive to fix. A new 16 SEER2 system uses approximately 38 percent less energy than a 10 SEER unit, and many qualify for the federal energy tax credit. KIC Refrigeration helps Glens Falls homeowners evaluate repair versus replacement based on equipment age, repair history, refrigerant type, and projected energy savings.
AC refrigerant recharge in Glens Falls costs $200 to $500 for R-410A systems at roughly $50 to $80 per pound, and $400 to $1,200 for older R-22 systems at $80 to $150 per pound due to the phaseout-driven supply shortage. However, simply adding refrigerant without finding the leak is a temporary and wasteful fix — the charge will leak out again in weeks or months and you will be back in the same situation. KIC Refrigeration always locates the leak first using electronic leak detectors and UV dye, repairs the leaking component, evacuates the system to remove moisture and air, and recharges by weight to the manufacturer specification. This approach fixes the problem permanently.
Most AC repairs in Glens Falls are completed in 1 to 2 hours during a single service visit. Capacitor and contactor replacements are quick fixes that take 15 to 30 minutes of hands-on time. Fan motor and blower motor replacements take 1 to 2 hours including wiring and testing. Compressor replacement is the most time-intensive repair at 3 to 6 hours because it requires refrigerant recovery with an EPA-certified machine, compressor removal, new compressor installation, nitrogen-purged brazing, pressure testing at 300 PSI, evacuation to below 500 microns, and recharging by weight. KIC Refrigeration arrives at your Glens Falls home with a fully stocked truck to complete most repairs in a single visit.
Hear from property owners who chose us for their heating and cooling needs.
"Called about a weird smell from the furnace. They came out, found a cracked heat exchanger, and explained the safety concern clearly. Grateful they caught it."
"Mini split repair was done right the first time. The outdoor unit had a refrigerant leak and they found it, fixed it, and recharged the system same day."
"KIC Refrigeration installed our whole-home HVAC system during the renovation. They coordinated perfectly with our contractor and stayed on schedule."